A Morristown door that needs a hip-check to close is binding on a frame that has drifted out of square. We fit, hang, and seal the door so the entryway is warm, secure, and quiet again. Free estimate, straight answer, no oversell.
When you feel a cold ribbon of air along the hinge side of a door, the seal has failed on the edge you rarely think to check. We correct the sag, reseat the hinges, and close the gap at the top corner where the draft was coming through.
A storm door with a closer that no longer catches lets the door swing wide and slam in any decent wind. We make the opening right and set the door into it, so the fix holds instead of needing another shim next year.
Quality doors fit to the opening and hung to swing clean and latch tight.
We pull the binding slab, square up an opening that has drifted out of plumb, and set the new door so it latches with one light push. It swings clean, seals all the way around, and keeps the weather where it belongs — outside.
Door replacement & installation →Insulated fiberglass and steel entry doors stand up to the weather and hold their seal year after year. We install Therma-Tru and other quality lines, each one fit to your opening and hung to swing and latch right.
Therma-Tru entry doors →From a warped interior slab to a patio slider off its track, we get doors moving smoothly and closing tight again. We fit the right door to the opening and install it so it works the way it should.
Masonite doors →Ballpark what a new door takes before you call, then let us put real numbers to it. Our door calculator gives you a starting point, and a free in-home estimate gives you the straight answer.
Door cost calculator →Precise measurement, a plumb hang, and a final walkthrough.
We check each threshold for where it’s worn and each sweep for where it’s gone hard and stopped sealing. Those small parts often explain a big draft, and we’d rather tell you that than sell around it.
Each door’s opening gets read three ways for width and two ways for square before we commit. That’s the difference between a door that seals on its own and one you have to lean on.
The old door comes out, the opening gets sealed against wind and water, and the new one is set level into it. We don’t move on until the swing is clean and the seal is tight.
We finish by walking the house door by door, letting you confirm each seal and swing yourself. When every opening passes, we clean up fully and back the whole install in writing.
Choose the contractor who aligns the strike to the latch, so the deadbolt throws clean on the first try.
We install proven brands matched to your home, not whatever is cheapest.
We say so when a door’s fine as it is.
A tight install ends the cold spot you feel near the door.
We match a quality door to your opening, your room, and your budget.
We set glass that stays warm enough to keep frost off.
We measure exact so the door sits square the first time.
A slab sitting proud of the stops means the frame twisted and the door can’t seat flat anymore. Patching the trim around a leaking door leaves the water path intact, so the stains and drafts return. Nail Force corrects the racked opening, resets the threshold, and hangs a slab that stops the wind at the seam.
The scope is on paper up front, listing each slab, jamb, and threshold, so nothing is left unsaid. Our workmanship is warrantied on paper; anything we install that leaks or sticks is ours to correct. Nail Force Contracting is licensed and insured in New Jersey under HIC #13VH14050100 — call (973) 713-1053 to get on the schedule.
If yours isn’t here, call us. We’ll give you a real answer.
Looks don’t tell the story; the seal and the fit can fail behind a good-looking slab. Most of the time the opening moved and the door is just paying for it. We read the fit first, because a door is only as good as its opening. We are glad to walk your home and show you what we mean, (973) 713-1053.
A slight warp can sometimes be eased, but a badly warped slab will keep fighting the latch. The slab, the frame, and the hardware all have to work together for a door to operate. We look at every edge of the seal and every corner of the fit on your home. Reach out at (973) 713-1053 and we will sort out what each door needs.
The added floor height leaves too little clearance, so the slab catches. Where this nets out depends on the opening as much as the slab. We would rather fix the fit right than have you chasing the same draft. Call (973) 713-1053 and we will get eyes on the problem.
We provide door services throughout Morris County, including:
All Services in Morristown
View all services we offer in Morristown, NJ →More Services in Morristown
Roofing in Morristown Siding in Morristown Windows in Morristown Doors in Morristown Painting in MorristownNearby Towns
Roxbury Riverdale Washington Township Denville Rockaway BoroughOne exterior door or every door in the house — call us or request online and we’ll get right back to you with a straight answer.
