Licensed & Insured Exterior Contractor — Free Estimates
(973) 713-1053
All Services in Franklin, NJ
Doors in Franklin

Doors in Franklin, NJ

Local. Licensed. Done Right.

Most Franklin door trouble starts at the seal, the threshold, and the hang — not the slab alone. We true the frame, hang the slab, and seal the sill so the entryway is comfortable again. Free estimates — call or request online.

Stop Heating the Outdoors Through Your Franklin Doors

Once the threshold caulk cracks and lifts, water finds the joint and starts working under the sill toward the subfloor. We seal the entry tight, top to bottom and hinge side to latch, so the cold ribbon of air along the edge is gone.

A rear door that leaks a fine drift of cold along the top edge is hung low, leaving the seal open where you can’t see it. We restore the jamb, reseat the hinges, and hang the slab so it stops rocking loose in a frame that had spread.

Door Services for Franklin Homes

Pointed straight at the drafts, sticking slabs, failing weatherstrip, and worn-out hardware that wear an exterior door out.

Door Replacement & Installation

We pull the binding slab, square up an opening that has drifted out of plumb, and set the new door so it latches with one light push. It swings clean, seals all the way around, and keeps the weather where it belongs — outside.

Door replacement & installation →

Entry Doors We Install

Insulated fiberglass and steel entry doors stand up to the weather and hold their seal year after year. We install Therma-Tru and other quality lines, each one fit to your opening and hung to swing and latch right.

Therma-Tru entry doors →

Interior & Specialty Doors

From a warped interior slab to a patio slider off its track, we get doors moving smoothly and closing tight again. We fit the right door to the opening and install it so it works the way it should.

Masonite doors →

Plan Your Door Project

Ballpark what a new door takes before you call, then let us put real numbers to it. Our door calculator gives you a starting point, and a free in-home estimate gives you the straight answer.

Door cost calculator →

From Measurement to Walkthrough in Franklin

Read the opening, set it right, and prove it seals and latches before we leave.

1

The First Visit

The consultation is free, and it’s where we separate the doors that need replacing from the ones that don’t. You get an honest read, not a sales pitch.

2

We Measure Every Opening

We check every opening against a level, not just a tape, so plumb is proven and not assumed. A frame that looks straight and measures crooked gets flagged right there.

3

Set Square and Sealed

We hang the door in a squared opening so the weatherstrip meets the slab with even pressure everywhere. Uneven pressure is a leak waiting to happen, and we don’t leave one.

4

The Final Check

We test each threshold for a tight seal and each latch for a clean catch while you watch. Nothing’s done until you’ve seen it, and the labor is backed in writing when we go.

Done Right, Once

Go with the people who fix the opening the measurements found, so the finished door seals for good, not just for a season.

Repair When It Holds

If a unit is sound, we fix it rather than sell a swap.

No More Condensation

We end the condensation by setting glass that holds its temperature.

Bills Come Down

Sealing the leaks at the door takes pressure off your heating.

Comfort Year-Round

A sealed, efficient unit holds comfort through summer and winter both.

Squared To The Wall

We square the opening to the wall so the new door seats true.

Built To Seal

Sealed on every side, the opening keeps weather out.

Request a Free Assessment

Why Done-Right Beats Done-Fast

A slab dragging on the threshold means the opening lost its square long before the door showed wear. Oiling the hinges quiets the squeak but does nothing for the sag that made the door drag. Nail Force resets the patio slider on a leveled sill so it glides its track and meets the jamb at the stop.

You approve a clear, written scope before anything starts, so there are no mid-job surprises. The install is backed on paper, and if a door we set no longer seals, we come out and set it right. We carry NJ HIC #13VH14050100 and are licensed and insured; call (973) 713-1053 and we’ll come take a look in person.

Door Questions — Franklin, NJ

If yours isn’t here, call us. We’ll give you a real answer.

Why does my back slider fog worse than my front door?∨

Sliders have large glass areas, so a failing seal shows condensation sooner. Where this nets out depends on the opening as much as the slab. We assess the frame’s condition before deciding the door’s fate. Phone (973) 713-1053 and we will read every opening and tell you straight.

Can you make an old opening fit a standard new door?∨

Yes; we true the opening and set a properly sized door so it seals right. Most door problems are fit problems wearing a different face. We check the threshold and the frame, not just the slab you point at. We are one call away at (973) 713-1053 for a clear, written quote.

Why does my door let in a draft even after I added a sweep?∨

A sweep helps the bottom, but if the sides and top leak, the fit still needs work. The answer turns on the slab, the seal, and the square of the opening. We tell you straight what is worth saving and what is past it. We will gladly come look, (973) 713-1053 starts it.

Serving Franklin and Nearby Hunterdon County Towns

We provide door services throughout Hunterdon County, including:

View all Hunterdon County towns we serve →

Free Door Estimate for Franklin, NJ

One exterior door or every door in the house — call us or request online and we’ll get right back to you with a straight answer.

📞 Call (973) 713-1053 💬 Text Us